Description
RGB LED Strip for racing drones Matek RGB LED WS2812B W/ MCU
This LED comes as a single stick with 8 individually addressable RGB LEDs & STM MCU. It provides dual control modes and can be used for decorating your FPV Quads
Features
- Built-in 8pcs RGB LED WS2812B & 1pc MCU
- Dual modes: MCU control & Cleanflight control
- MCU mode: 7 colors (White, Green, Red, Blue, Yellow, Cyan, Magenta)
- 4 status (Constant light, Slow flash, Fast flash, Voilent flash
- CleanFlight mode: support for CC3D, Naze32, SPRacingF3, etc. with CleanFlight firmware
Working voltage range: 4.5~5.2V DC
Setup video:
Power consumption
MCU mode (5V IN):
White: 1.8W /0.36A
Green/Red/Blue: 0.6W/0.12A Yellow/Cyan/Magenta: 1.2W/0.24A
Mounting
30mm, Φ2.6mm Size & Weight: 65x10mm, 3g
Setup
1. Connect the LED strip to 5V power source (Pin 5V & GND).
2. Press the button, scroll through the color within White, Green, Red, Blue, Yellow, Cyan, Magenta.
3. Hold the button 2s to enter the setting of LED mode, then press the button to set it within
MCU mode (the 1st LED Constant light, Slow flash, Fast flash, rapid flash)
CleanFlight mode (the 1st LED OFF)
4. The mode will be saved if no action within 10 seconds.
5. If MCU mode is choosed & saved, the color can be altered by pressing the button. 6. If CF mode is choosed & saved, Pls connect the DIN to the Flight Controller.
Wiring
CC3D: Pin Motor-5
Naze32: RC5 pad
SPRacing F3: LED_STRIP pad
set the LED status in the GUI according to CleanFlight guide.
7. If the LED status is garbled when setting Cleanflight mode to the MCU mode, remove the DIN & re-energize it.
Reviews
There are no reviews yet.